Sawstop T-Glide Fence System User Manual download pdf (Page 5)

Installing Your T-Glide Fence System

miter slots

front rail

Use M8 x 16 bolts

1. Begin mounting the front rail (the longer of the two rails) to the front edge of your saw by centering the notches

in the rail with the two miter slots in the table, aligning the two holes in the rail between the notches with the two

corresponding holes in the front edge of the table, and threading an M8 x 16 countersunk socket head bolt into

each hole (see Fig. 1). Aligning the two holes between the notches aligns all the other holes used in mounting

the rail to your saw. Not all the holes are used to mount the rail to your saw; different holes are used for different

saws. Thread the bolts into the corresponding holes, and tighten them using a 5 mm hex key.

notch

Fig. 1

Installing your T-Glide

Fence System on your

SawStop

Professional Cabinet Saw

SawStop

SawStop T-Glide Fence System - Professional Series II 3

1 2 3 4 5 6 7 8 9 10 ... 35 36

No comments

Sawstop T-Glide Fence System User Manual Page 5