Sawstop T-Glide Fence System User Manual download pdf (Page 19)

Installing Your T-Glide Fence System

18. Locate the fence and the red fence handle. Thread

the handle into the cam lock on the front of the fence

(see Fig. 18).

17. Locate the front tube and the T-Glide Rails Hardware Pack. If you have a 36” fence system, remove seven

M8 x 16 hex head bolts and seven M8 lock washers from the T-Glide Rails Hardware Pack. If you have a 52”

fence system, remove nine M8 x 16 hex head bolts and nine M8 lock washers from the T-Glide Rails Hardware

Pack. Position the tube on the front rail with the rulers facing up and the 12-inch ruler on the left. The powder

coated surfaces of the tube and rail can be slick, so be careful that the tube does not fall off the rail. Align the

holes in the rail with the holes in the bottom of the tube. Place an M8 lock washer on each M8 x 16 hex head

bolt and insert the bolts through the rail and into the threaded holes in the bottom of the tube (see Fig. 17).

Hand tighten the bolts; do not fully tighten them.

Fig. 17

Fig. 18

SawStop

T-Glide Rails Hardware Pack

Countersunk Socket Head Bolts,

M8 x 25 (8)

Washers,

M8 (8)

Lock Washers,

M8 (17)

Professional Series

Countersunk Socket

Head Bolts, M8 x 16 (8)

Hex Head Bolts, M8 x 16 (9)

Hex Nuts,

M8 (8)

thread the handle into

the cam lock

SawStop T-Glide Fence System - Professional Series II 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

No comments

Sawstop T-Glide Fence System User Manual Page 19